Table of Contents | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
|
Example: server to server transfer without touchdown:
Graphviz |
---|
<source>
digraph "Example: Server to Server Transfer" \{
</source>
rankdir=LR;
edge [
color="#31CEF0"
];
source_server [label="Data Source (sFTP)"];
target_server [label="Data Target (FTP)"];
jade_client [label="JADE Client \n API \n JITL Job"];
jade_config [label="JADE Configuration"];
source_server->target_server [label="data transfer"];
source_server->jade_client [dir=both label="commands" color="grey"];
jade_client->target_server [dir=both label="commands" color="grey"];
jade_config->jade_client [color="green"];
\}
|
A profile definition for Server to Server transfer, from sftp to ftp:
Code Block |
---|
[ftp_server_2_server]
ssh_auth_method=password
source_user=kb
source_password=*****
source_ssh_auth_method=password
source_host=wilma.sos
source_protocol=sftp
source_port=22
target_user=test
target_password=*****
target_host=8of9.sos
target_protocol=ftp
target_port=21
file_spec=^.*\.txt$
operation=copy
log_filename=$\{TEMP\}/sosftphistory.log
|
In this example all files with the file name extension ".txt" should be transfered from JADE server where JADE is installed to the server "wilma" via sftp to the server 8of9 by ftp. the folders are not explicitely specified and therefore the "home" folders of the user are selected.. JADE will check the file to transferred for completeness by using steady state parameter
To start this with the command line client one must type
...
To make the profile more reusable and readable it is possible to reuse profiles in the way like this:
Code Block |
---|
[globals] log_filename=$\{TEMP\}/sosftphistory.log [wilma_as_source] ssh_auth_method=password source_user=kb source_password=***** source_ssh_auth_method=password source_host=wilma.sos source_protocol=sftp source_port=22 [8of9_as_target] target_user=test target_password=***** target_host=8of9.sos target_protocol=ftp target_port=21 [globals] log_filename=$\{TEMP\}/sosftphistory.log |
The profiles for wilma as source and 8of9 as target are defined once. They could be used as many time as needed. There is a "globals" profile as well.
Now we will specify the profile again:
Code Block |
---|
[ftp_server_2_serversftp_to_wilma_with_stedy_state_check] include=wilma_as_source,8of9_as_target operation=copy file_spec=^.*\.txt$ [ftp_more] include=wilma_as_source,8of9_as_target operation=move file_spec=^.*\.(txt|pdf|dat)$ source_folder=/outbound/daily target_folder=/inbound/transfer check_steady_state_of_files=true steady_state_count =30 check_steady_state_interval = 1 |
The "include" parameter will include the named profile snippets in the order they are defined. The "globals" profile is included automatically, no need to specifiy it in an include parameter.
The profiles must be defined in the same settings file.