...
The next code block shows part of the log file for Order1. This shows the log information for Job3 and the start of Job6. The following points are relevant:
- Line 66 68 of the listing shows that Job3 is exiting with return code 1.
- Line 69 shows that an error has been logged.
- The end of processing of the node for Job3 is noted in line 70.
- Line 70 shows that an error is loggedLine 71 72 shows that the state is set for starting Job6 - the job at the node specified in the to_state element that was configured for node 3.
...
- The ID from the order generating the order for has been taken over by default. This is shown in the listing in line 24.
- The orderParameter order_parameter value from Order0 on JobChainA has also been taken over and shown in line 36.
- The ParameterJob3 parameter_job_3 parameter, which is set with value "ParameterReturnCodeJob3" is shown in line 33. This parameter was set in the on_return_code element at the node for Job3 in JobChainA.
...